Scroll or pinch to zoom · drag to move · double-click to zoom in
100%
Vector files for
Layout notes
How the VeeTable system fits together
64 mm Vee grid. Every Vee is 90°, 4 mm deep and 8 mm wide at the surface. Bins sit on whole 64 mm cells.
96 mm dog holes. 96 mm is 1.5 cells, so holes alternate between a Vee line and a cell centre. The two patterns line up every 192 mm.
Centred holes. A cell count divisible by 3 (6, 9, 12, 18…) can't centre the most holes, so one side ends up half a cell further in. Go one cell up or down, or choose "Always centred".
Holes stay inside the frame. No hole centre is closer than 32 mm to the outer Vee.
Cut order. Drill the dog holes and fixing holes first, then cut the Vees.
Bin generator
Storage bins that lock into your VeeTable
Design your own bins on MakerWorld and print them at home. They drop into the 64 mm Vee grid and stay put while you slide timber and tools across the bench. When you need one, lift it straight out.
What you can make
Any size from 1 × 1 to 6 × 6 grid units (64 to 384 mm), any depth from 15 mm
Stacking rim so bins stack and lock on each other
Matching lids that locate on the bin and stack too
Dividers along and across, spaced how you like
Scoops on the front, or in every compartment
¼″ hex bit holders, a whole bin, or a section in one side or corner
Text labels, engraved or raised, on the front, the label shelf or the lid
Prints without supports, with 3 mm walls and soft rounded edges
Free for personal use. Opens the customiser on MakerWorld.
Bins stacked two high with a labelled lidA hex bit holder with 20 bitsA tray with a hex bit section, dividers and a label shelfA divided tray with a scoop in every compartment
Ideas, feedback or found a problem?
Tell us what would make VeeTable better, for the table designer or the bins. It's a short form and takes a minute. Leave your email only if you'd like a reply.
